BYD Shark 6 Towing Specs: Premium vs Performance Capacity, Towball Load and GCM
The current Shark 6 range no longer has one universal towing number. The Premium can tow up to 2,500 kg…
Table of contents
The current Shark 6 range no longer has one universal towing number.
The Premium can tow up to 2,500 kg braked with a 250 kg maximum towball download and a 5,750 kg GCM. The Performance lifts those figures to 3,500 kg braked, 350 kg towball download and 6,650 kg GCM. Both share a 750 kg unbraked limit.
This article focuses primarily on the Premium’s towing limits while highlighting where the Performance differs. The towing capacity figure is only the first check. A Shark 6 with a canopy, drawers, passengers and gear must also stay within GVM, GCM, towball download and axle ratings at the same time.
Shark 6 towing specifications at a glance
| Towing specification | Dynamic Cab Chassis | Premium | Performance |
| Braked towing capacity | 2,500 kg | 2,500 kg | 3,500 kg |
| Unbraked towing capacity | 750 kg | 750 kg | 750 kg |
| Maximum towball download | 250 kg | 250 kg | 350 kg |
| GVM | 3,500 kg | 3,500 kg | 3,500 kg |
| GCM | 5,750 kg | 5,750 kg | 6,650 kg |
| Kerb weight | 2,600 kg | 2,710 kg | 2,775 kg |
| Nominal payload | ~900 kg* | ~790 kg | ~725 kg |
*The Dynamic’s final payload depends on the fitted tray or body. BYD recommends confirming the completed configuration with the dealer or body builder. Premium and Performance payload figures are derived from published kerb weight and GVM and can vary with fitted accessories.
What does 2,500 kg braked towing capacity mean?
The Premium can tow a trailer with a maximum Aggregate Trailer Mass (ATM) of up to 2,500 kg, provided:
- The trailer has an appropriate braking system
- The approved towbar and hitch are rated for the load
- The maximum 250 kg towball download is not exceeded
- The vehicle remains within its 3,500 kg GVM
- The combination remains within the 5,750 kg GCM
- Front and rear axle limits remain compliant
- The trailer itself remains within its own ATM and GTM ratings
The 2,500 kg figure is a maximum technical limit, not a guarantee that every Premium can carry a full canopy build, passengers and a 2,500 kg trailer without further calculation. The actual permitted trailer weight can be reduced by excessive vehicle loading, an overweight rear axle, towbar or hitch limitations, trailer limits, incompatible accessories or state and territory towing requirements.
Common mistake: Assuming “2,500 kg towing capacity” means you can tow 2,500 kg regardless of how heavily the ute is loaded. The tow rating is one limit. GVM, GCM and axle ratings are separate limits that all apply simultaneously.
What does the 750 kg unbraked limit mean?
An unbraked trailer does not use its own service braking system. All stopping force comes from the Shark 6. The maximum published unbraked towing capacity is 750 kg across the entire current range (Dynamic, Premium and Performance).
The 750 kg total must include trailer structure, spare wheel, accessories, tools, equipment, camping gear, water and the load being transported. A trailer with a 500 kg tare weight does not have 750 kg of cargo capacity. It has approximately 250 kg remaining before reaching a 750 kg ATM, subject to its individual compliance plate.
In most Australian states, trailers with a GTM exceeding 750 kg are required to have their own braking system. This is a legal requirement, not a recommendation. Transport for NSW and equivalent state authorities enforce trailer braking and load restraint requirements.
What is the Shark 6 towball load limit?
Premium and Dynamic: 250 kg maximum
The maximum published towball download for the Premium and Dynamic Cab Chassis is 250 kg. The BYD handbook also states the vertical load should be at least 4% of total trailer weight or 25 kg, whichever is greater, without exceeding the maximum.
Performance: 350 kg maximum
The Performance raises the towball limit to 350 kg, matching its higher 3,500 kg braked towing rating.
Towball download counts against payload
Towball download transfers onto the ute when the trailer is coupled. It contributes to actual vehicle mass, remaining payload, rear axle load, GVM and suspension load.
Here is a simple Premium example:
| Item | Weight (kg) |
| Nominal payload | 790 |
| Canopy and storage | 220 |
| Two occupants | 160 |
| Normal gear | 100 |
| Towball download | 250 |
| Remaining nominal payload | ~60 kg |
This demonstrates why a ute can remain below its towing capacity figure but still exceed GVM or an axle limit. The BYD Shark 6 towing capacity and setup guide covers the full towing interaction with payload, canopy builds and brake controller setup.
The maximum towball figure is a ceiling, not a universal target. The correct download depends on the trailer design, loading instructions and the ratings of every component in the towing system.
What does the Premium’s 5,750 kg GCM mean?
GCM in plain English
Gross Combined Mass is the maximum permitted mass of the loaded vehicle and loaded trailer combination. In practical weighing terms:
Actual coupled vehicle mass + actual trailer axle mass = actual combined mass
The result must not exceed the applicable GCM.
Why 3,500 kg GVM plus 2,500 kg ATM does not automatically equal 6,000 kg GCM
When the trailer is connected, the towball download transfers from the trailer onto the vehicle. A 2,500 kg ATM trailer with 250 kg on the towball would place approximately 2,250 kg on its own axles.
At the maximum published figures:
| Item | Mass (kg) |
| Coupled vehicle mass (at GVM) | 3,500 |
| Trailer axle mass (ATM minus ball weight) | ~2,250 |
| Combined mass | ~5,750 kg |
| GCM limit | 5,750 kg |
This shows how the Premium’s published limits relate to one another. At maximum figures, there is essentially zero margin. Any deviation (heavier vehicle, heavier trailer, higher ball weight) pushes the combination over GCM.
The Performance’s 6,650 kg GCM provides significantly more headroom when towing at 3,500 kg capacity.
Common mistake: Simplifying GCM as “subtract the trailer weight from GCM and that is how much the ute can weigh.” This ignores towball weight transfer. The vehicle’s coupled mass includes the towball download from the trailer. The trailer’s axle mass is the trailer ATM minus the towball download. Both numbers must be calculated correctly.
Worked Premium towing example
Here is one clear hypothetical scenario:
| Item | Mass (kg) |
| Loaded Shark 6 before trailer connection | 3,200 |
| Trailer ATM | 2,500 |
| Towball download (transferred to vehicle) | 250 |
| Approximate trailer axle mass | 2,250 |
After connecting the trailer:
| Check | Figure | Limit | Margin |
| Coupled vehicle mass | ~3,450 kg | 3,500 kg GVM | ~50 kg |
| Actual combined mass | ~5,700 kg | 5,750 kg GCM | ~50 kg |
This hypothetical setup leaves approximately 50 kg below both GVM and GCM. That is technically legal but offers almost no margin for error.
All figures are hypothetical. Real vehicles and trailers need to be weighed because published kerb weight, accessory weights and towball download can vary.
How a canopy changes the towing calculation
A canopy does not normally reduce the vehicle’s published towing capacity rating. However, it uses payload and can make the vehicle exceed GVM, GCM or an axle limit before reaching the maximum trailer weight.
Count everything: canopy shell, mounting hardware, drawers and shelving, fridge, auxiliary battery, roof rack, awning, water, tools or camping equipment, passengers and towball download. The BYD Shark 6 payload and GVM guide covers the full weight calculation with worked examples for tradie, touring and towing scenarios.
Key principle: Towing capacity tells you the maximum trailer rating. Payload tells you how much equipment and towball weight the ute can carry. GCM determines whether the complete combination remains legal. All three must be satisfied simultaneously.
Call us on 02 9627 8666, text 0440 130 098 or visit our showroom at 20 Walker St, South Windsor, Sydney to run through your towing numbers with a specific canopy build.
How does the Shark 6 compare with diesel utes?
Many mainstream 4×4 diesel utes publish maximum braked towing figures of 3,500 kg. Ford lists up to 3,500 kg for the Ranger. Toyota lists 3,500 kg for relevant HiLux 4×4 variants. Mitsubishi publishes up to 3,500 kg for the Triton.
Premium comparison
The Premium’s 2,500 kg sits 1,000 kg below the common diesel benchmark. It remains suitable for camper trailers, smaller caravans, boats, equipment trailers and lighter work trailers, provided the complete trailer and combination weights remain compliant.
Performance comparison
The Performance matches the headline 3,500 kg braked figure. Payload, GCM, towball load, energy consumption and real loaded performance still need to be considered separately. A matching tow rating does not mean identical towing capability once the complete build is factored in.
Premium or Performance for towing?
Choose Premium when:
- The trailer is comfortably below 2,500 kg
- More pickup payload is valuable (~790 kg vs ~725 kg)
- Purchase price matters ($57,900 vs $62,900)
- The vehicle will carry a canopy but tow lighter equipment
- 3,500 kg towing is genuinely unnecessary
Choose Performance when:
- The trailer requires more than 2,500 kg capacity
- Up to 350 kg towball download is needed
- The higher 6,650 kg GCM provides a better combination mass envelope
- The owner accepts its lower nominal payload before trailer connection
The Performance is the stronger towing variant. But its higher kerb weight (2,775 kg vs 2,710 kg) leaves less nominal pickup payload than the Premium. A higher towing rating does not automatically mean more capacity for canopy accessories and cargo. For a deeper look at how towing interacts with a complete touring canopy build, see the dedicated touring guide.
Other limits to check before towing
Before hitching up, confirm compliance with every applicable limit:
- Vehicle braked or unbraked towing limit
- GVM (3,500 kg for all current Shark 6 variants)
- GCM (5,750 kg Premium / 6,650 kg Performance)
- Front axle rating
- Rear axle rating
- Maximum towball download
- Towbar rating
- Tongue or hitch rating
- Trailer ATM and GTM
- Trailer axle rating
- Tyre load ratings
- Brake controller requirements (required by law in most states for trailers over 750 kg GTM)
- State and territory towing regulations
The lowest applicable rating controls the setup. The NTC Load Restraint Guide for Light Vehicles provides the baseline standard for securing cargo on the vehicle and trailer.
Common Shark 6 towing spec mistakes
- Stating that every Shark 6 tows only 2,500 kg (the Performance tows 3,500 kg)
- Applying the Performance’s 3,500 kg rating to the Premium
- Ignoring towball download when calculating remaining payload
- Treating 250 kg as the required ball weight rather than the maximum
- Confusing GVM and GCM (GVM is the vehicle alone; GCM is the vehicle plus trailer)
- Adding vehicle mass directly to trailer ATM without accounting for towball weight transfer
- Assuming braked capacity applies to an unbraked trailer (unbraked limit is 750 kg)
- Using the trailer’s empty weight rather than its loaded ATM
- Forgetting canopy and drawer weight when calculating available payload for towing
- Assuming a GVM upgrade automatically increases towing capacity or GCM
- Checking GCM but not rear axle load
- Relying solely on brochure kerb weight instead of weighing the actual vehicle
- Failing to weigh the loaded combination before a major tow
Shark 6 towing calculation checklist
- < > Exact Shark 6 variant confirmed (Premium, Performance or Dynamic)
- < > Braked towing limit recorded for the correct variant
- < > Unbraked limit recorded (750 kg for all variants)
- < > Maximum towball download recorded (250 kg or 350 kg)
- < > GVM recorded (3,500 kg)
- < > GCM recorded (5,750 kg or 6,650 kg)
- < > Front and rear axle limits recorded
- < > Canopy and accessory weights included in vehicle load
- < > Passenger and luggage weight included
- < > Trailer ATM confirmed from the trailer’s compliance plate
- < > Loaded towball download measured or estimated
- < > Trailer axle mass calculated (ATM minus towball download)
- < > Vehicle weighed while coupled to the trailer
- < > Brake controller installed and tested (if required)
- < > Towbar and hitch ratings confirmed
- < > Tyre ratings confirmed
- < > Remaining GVM and GCM margins calculated
What we recommend at Oz Canopies & 4×4: If you are planning a Shark 6 canopy build and tow regularly, run the full payload and GCM calculation before committing to accessories. The difference between a comfortable towing setup and a borderline one often comes down to 50 kg of canopy weight or one extra accessory that tips the balance. Browse the Shark 6 canopy build options to compare lightweight canopies that preserve towing headroom.
FAQs
How much can a BYD Shark 6 tow?
Can every Shark 6 tow 3,500 kg?
What is the Shark 6 towball load limit?
Does towball download count toward payload?
What is the Shark 6 GCM?
Can the Premium tow 2,500 kg while at full GVM?
Does a canopy reduce Shark 6 towing capacity?
Does a GVM upgrade increase towing capacity?
Your next step: check all five limits, not just one
The current BYD Shark 6 Premium is rated to tow up to 2,500 kg braked, 750 kg unbraked, with up to 250 kg towball download, within a 5,750 kg GCM. The Performance raises those to 3,500 kg braked, 350 kg towball and 6,650 kg GCM.
The towing capacity figure is only the first check. A Shark 6 canopy build must also leave enough room for people, equipment and towball download within the vehicle’s GVM, GCM and axle ratings.
For the full picture of how towing fits into a complete Shark 6 canopy build, the BYD Shark 6 canopy and tub setup guide ties every element together.
Call us on 02 9627 8666, text 0440 130 098 or visit our showroom at 20 Walker St, South Windsor, Sydney to plan a tow ready Shark 6 build.