Collection: Tub Slides

Tub slides that roll the floor of your ute out past the tailgate. Shop HSP Load Slides for dual cab utes from the Ranger, HiLux and D-MAX to the Gladiator and Shark 6, a universal 1400 x 1000 mm slide and ARB DragMat mats.

Showing products for your

Showing 24 of 28 results

Gear up for adventure
Gear up for adventure
Limited time sale

Gear up for adventure

Save big on canopies, racks, drawers & morethis season

The Reach Problem in a Dual Cab Tub

Anything pushed against the bulkhead of a dual cab tub sits well beyond arm's length from the tailgate. Under a canopy or roller shutter it gets worse, because you cannot lean in over the side either. Most owners end up kneeling on the tailgate or dragging a heavy box across the floor. A slide changes the geometry: the whole floor travels out to you at tailgate height, with the load still sitting on it.

HSP Load Slides

Most of this collection is HSP's Load Slide, made for individual tubs rather than one size for all. Each platform keeps its 250 kg rating even at full extension, travels out up to 75 percent of its length, and latches at points roughly every 20 cm, so you can stop it part way and it holds there once you let go of the handle. The custom cut side rails form a lip that keeps cargo on the deck and double as anchor points for straps.

HSP lists slides for dual cab tubs on a wide spread of utes: PX and Next Gen Ranger and Raptor, the N80 HiLux it calls the Revo and the N90 it calls the Travo, both Amarok generations, Triton MQ and MR plus the 2024 Triton, Navara NP300 and D23, D-MAX before and after 2021, BT-50 from 2013 to 2020 and from 2020, RG Colorado, X-Class, LDV T60, GWM Cannon and Cannon Alpha, BYD Shark 6 and Jeep Gladiator. Popular fitments are grouped in Ranger tub slides, HiLux slides, Triton tub slides, Amarok slides, BT-50 tub slides and Colorado slides.

Match the Slide to What Lines Your Tub

This is where most ordering mistakes happen. For the PX Ranger and Raptor, the Next Gen Ranger and Raptor, the NF Amarok from 2023 and the BT-50 from 2013 to 2020, HSP cuts the slide two ways:

  • Suits Genuine Tubliner: sized to sit inside the manufacturer's own liner, which wraps the wheel arches and eats into floor width
  • Suits No Liner, Spray on Liner or 5 Piece Liner: sized for a bare floor, a sprayed coating or a sectional liner such as ARB's Sportguard

Order the wrong cut and the frame either refuses to seat between the arches or leaves gaps down each side. If you are about to change liners, buy the slide for the liner you will end up with. Compare floor protection in our tub liner range.

Trims and Deck Shapes

Liner type is not the only split. On the N80 HiLux, the SR's J Deck tub takes its own slide, while the SR5, GR and Rugged-X share another. The N90 slide covers the SR, SR5, GR and Rugged-X together. Triton slides divide at 2024 and D-MAX slides at 2021. The T60 slide is listed for the standard dual cab tub, so Mega Tub owners should check with us first.

The Universal Slide

For utes outside HSP's list, the universal slide measures 1400 x 1000 mm and is rated to 350 kg. It runs on heavy duty ball bearings, extends 900 mm and sits about 160 mm above the tub floor at its highest point. Spring loaded latch pins hold it in several positions, released by a push button in the grab handle, and six built in tie down points keep loads in place. It bolts to the tub floor with a handful of fasteners and works over any liner. Grab a tape measure first and check your floor length and the gap between the wheel arches.

ARB DragMat: A Lighter Option

Not every tub needs bearings. ARB's DragMat is a high walled HDPE tray with a non slip TPE top and moulded grab handles. Its underside glides over a bare tub or spray on liner, so you simply pull it toward the tailgate to reach what is on it. It handles loads over 100 kg, sits loose without drilling and lifts out for cleaning. We carry the original DragMat and the DragMat V2.

Height, Payload and Restraint

A slide raises the floor, which matters under a hard lid or roller shutter and inside a canopy fitted with shelving. Measure from the deck to the underside of the cover before planning a fridge or drawers on top. The slide's own weight comes out of payload along with the canopy, fridge and everything else, so do the sums for your ute. Strap cargo to the anchor points before you drive, just as you would on the tub floor. If you would rather have lockable compartments than an open deck, compare our drawer systems, or step back to the full storage and tub accessories range.

Fitting

HSP slides bolt into the tub, and NSW customers can have them fitted at South Windsor, often alongside a liner, canopy or cover so everything lines up the first time.

Call us on 02 9627 8666, text 0440 130 098, or visit our showroom at 20 Walker Street, South Windsor NSW 2756.

Have questions?

My Next Gen Ranger came with Ford's tubliner. Which HSP slide do I order?

The Next Gen slide marked Suits Genuine Tubliner. If that liner has been pulled out or replaced with a spray on coating, choose the other cut.

How much can a tub slide carry?

HSP rates its Load Slides at 250 kg, including at full extension. The universal slide is rated to 350 kg. Spread heavy items and strap them down.

Will a slide fit under my roller shutter or hard lid?

Usually, but it lifts the floor, so check the height left under the cover for whatever rides on the deck. Tell us your cover and we will confirm.

Is there a slide for the HiLux SR?

Yes. HSP makes a Revo SR version for the N80's J Deck tub, separate from the SR5, GR and Rugged-X slide.

How is a DragMat different from a slide?

A slide runs on rails or bearings and locks in position. The DragMat is a non slip tray you pull across the floor by its handles, with nothing fixed to the tub.

Do these slides suit space cabs or the T60 Mega Tub?

HSP lists its slides for dual cab tubs. For other body styles or the Mega Tub, call us before ordering.

Need help choosing?

Call us on 02 9627 8666 or chat with our team.